Show Igmpsnooping; Set Igmpsnooping Adminmode - Enterasys SECURESTACK C3 Configuration Manual

show igmpsnooping

Use this command to display IGMP snooping information.
Syntax
show igmpsnooping
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Usage
Configured information is displayed whether or not IGMP snooping is enabled. Status
information is displayed only when the function is enabled. For information on enabling IGMP on
the system, refer to "set igmpsnooping adminmode" on page 13‐3. For information on enabling
IGMP on one or more ports, refer to "set igmpsnooping interfacemode" on page 13‐4.
Example
This example shows how to display IGMP snooping information:
C3(su)->show igmpsnooping
Admin Mode..................................... Enable
Group Membership Interval...................... 260
Max Response Time.............................. 100
Multicast Router Present Expiration Time....... 0
Interfaces Enabled for IGMP Snooping........... ge.1.1,ge.1.2,ge.1.3
Multicast Control Frame Count.................. 0
Data Frames Forwarded by the CPU............... 0

set igmpsnooping adminmode

Use this command to enable or disable IGMP on the system.
Syntax
set igmpsnooping adminmode {enable | disable}
Parameters
enable | disable
Defaults
None.
Mode
Switch command, read‐write.
Enables or disables IGMP snooping on the system.
show igmpsnooping
SecureStack C3 Configuration Guide 13-3