About This Guide; Using This Guide; Structure Of This Guide - Enterasys SECURESTACK C3 Configuration Manual

Welcome to the Enterasys
access the device's Command Line Interface (CLI) and how to use it to configure SecureStack C3
switch devices.
Depending on the firmware version used in your C3 device, some features described in this
document may not be supported. Refer to the Release Notes shipped with your device to
determine which features are supported.

Using This Guide

A general working knowledge of basic network operations and an understanding of CLI
management applications is helpful before configuring the SecureStack device.
This manual describes how to do the following:
• Access the SecureStack CLI.
• Use CLI commands to perform network management and device configuration operations
• Establish and manage Virtual Local Area Networks (VLANs).
• Establish and manage static and dynamically‐assigned policy classifications.
• Establish and manage priority classification.
• Configure IP routing and routing protocols, including RIP versions 1 and 2, OSPF, DVMRP,
IRDP, and VRRP.
• Configure IPv6 routing, including OSPFv3.
• Configure security protocols, including 802.1X and RADIUS, SSHv2, PWA, MAC locking, and
MAC authentication.
• Configure access control lists (ACLs).

Structure of This Guide

The guide is organized as follows:
Chapter
CLI interface, an overview of local management requirements, an overview of the device's factory
default settings, and information about using the Command Line Interface (CLI).
Chapter
manage stacked switches.
Chapter
firmware image, how to configure WebView and Telnet, how to manage configuration files, how
to set the login password, and how to exit the CLI.
Chapter
routing and IPv6 routing licensed features.
®
SecureStack™ C3 Configuration Guide. This manual explains how to
1, Introduction, provides an overview of the tasks that can be accomplished using the
2, Configuring Switches in a Stack, provides information about how to configure and
3, Basic Configuration, provides how to set basic system properties, how to download a
4, Activating Licensed Features describes the commands used to enable advanced

About This Guide

Important Notice
SecureStack C3 Configuration Guide xxxiii