Clear Arpinspection Vlan - Enterasys SECURESTACK C3 Configuration Manual

clear arpinspection vlan

clear arpinspection vlan
Use this command to disable dynamic ARP inspection on one or more VLANs or to disable
logging of invalid ARP packets on one or more VLANs.
Syntax
clear arpinspection vlan vlan-range [logging]
Parameters
vlan‐range
logging
Defaults
If logging is enabled for the specified VLAN but logging is not entered with this command,
logging will remain enabled.
Mode
Switch command, read‐write.
Usage
You can use this command to disable dynamic ARP inspection on one or more VLANs, or you can
disable logging of invalid ARP packets on specified VLANs. To disable both logging and DAI, you
must enter this command twice.
Example
This example first displays the DAI configuration for VLAN 5, then disables DAI on VLAN 5, then
disables logging of invalid ARP packets on VLAN 5.
C3(su)->show arpinspection vlan 5
Source MAC Validation
Destination MAC Validation
IP Address Validation
Vlan
----
5
C3(su)->clear arpinspection vlan 5
C3(su)->show arpinspection vlan 5
Source MAC Validation
Destination MAC Validation
IP Address Validation
Vlan
----
5
17-28 DHCP Snooping and Dynamic ARP Inspection
Specifies the VLAN or range of VLANs on which to disable dynamic
ARP inspection.
(Optional) Disable logging of invalid ARP packets for the specified
VLANs.
Configuration Log Invalid
------------- ----------- --------------------------------
Enabled Enabled
Configuration Log Invalid
------------- ----------- --------------------------------
Disabled Enabled
Disabled
Disabled
Disabled
ACL Name
staticARP
Disabled
Disabled
Disabled
ACL Name
staticARP
Static flag
-----------
Enabled
Static flag
-----------
Enabled