Clear Arpinspection Filter - Enterasys SECURESTACK C3 Configuration Manual

C3(su)->clear arpinspection vlan 5 logging
C3(su)->show arpinspection vlan 5
Source MAC Validation
Destination MAC Validation
IP Address Validation
Vlan
----
5

clear arpinspection filter

Use this command to remove an ARP ACL from a VLAN or from the switch, or to remove a
permit rule from an existing ACL, or to change the status of static mapping to disabled.
Syntax
clear arpinspection filter name [permit ip host sender-ipaddr mac host
sender-macaddr] | [vlan vlan-range [static]
Parameters
name
permit
ip host sender‐ipaddr
mac host
sender‐macaddr
vlan vlan‐range
static
Defaults
If only the name is specified, the ACL is deleted from the switch.
Mode
Switch command, read‐write.
Usage
You can use this command to:
• Remove a configured ARP ACL from the switch, or
• Remove a permit rule from a configured ARP ACL, or
• Remove the association of an ARP ACL with a VLAN or VLANs, or
• Disable static mapping of an ARP ACL associated with a VLAN or VLANs.
Use the set arpinspection filter command to create and assign an ARP ACL.
Use the show arpinspection access‐list command to display currently configured ARP ACLs.
Configuration Log Invalid
------------- ----------- --------------------------------
Disabled Disabled
Specifies the name of the ARP ACL.
(Optional) Specifies that a permit rule is being deleted.
Specifies the IP address in the rule being deleted.
Specifies the MAC address in the rule being deleted.
(Optional) Specifies the VLAN or VLANs to which this command
should apply. Remove the ACL from the VLAN, if static is not specified
also.
(Optional) Specifies that static mapping should be disabled for this ARP
ACL for the specified VLAN or VLANs.
Disabled
Disabled
Disabled
ACL Name
staticARP
SecureStack C3 Configuration Guide 17-29
clear arpinspection filter
Static flag
-----------
Enabled