Activating Advanced Routing Features - Enterasys SECURESTACK C3 Configuration Manual

This chapter describes the IPv4 Routing Protocol Configuration set of commands and how to use
them.
For information about...

Activating Advanced Routing Features

Configuring RIP
Configuring OSPF
Configuring DVMRP
Configuring IRDP
Configuring VRRP
Configuring PIM-SM
Activating Advanced Routing Features
In order to enable advanced routing protocols, such as OSPF, DVMRP, VRRP, and PIM‐SM, on a
SecureStack C3 device, you must purchase and activate a license key. If you have purchased an
advanced routing license, and have enabled routing on the device, you can activate your license as
described in the chapter entitled "Activating Licensed Features."
If you are stacking your devices and require advanced routing features, all devices in the stack
must have a valid license.
If you wish to purchase an advanced routing license, contact Enterasys Networks Sales.
IPv4 Routing Protocol Configuration
Router: The commands covered in this chapter can be executed only when the device is in router
mode. For details on how to enable router configuration modes, refer to
Configuration Modes" on page 18-2.
Note: The command prompts used in examples throughout this guide show a system where the
VLAN 1 interface has been configured for routing. The prompt changes depending on your current
configuration mode, your specific device, and the interface types and numbers configured for
routing on your system.
20
"Enabling Router
Refer to page...
20-1
20-2
20-11
20-33
20-37
20-42
20-49
SecureStack C3 Configuration Guide 20-1