Packet Capture Commands; Purpose; Commands; Show Rmon Capture - Enterasys SECURESTACK C3 Configuration Manual

Packet Capture Commands

Packet Capture Commands
Note that packet capture filter is sampling only and does not guarantee receipt of back‐to‐back
packets.

Purpose

To display RMON capture entries, configure, enable, or disable capture entries, and clear capture
entries.

Commands

For information about...

show rmon capture

set rmon capture
clear rmon capture
show rmon capture
Use this command to display RMON capture entries and associated buffer control entries.
Syntax
show rmon capture [index [nodata]]
Parameters
index
nodata
Defaults
If no options are specified, all buffer control entries and associated captured packets will be
displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display RMON capture entries and associated buffer entries:
C3(rw)->show rmon capture
Buf.control= 28062
----------------------------------------------------------
FullStatus
Captured packets
Download size
Max Octet Requested 50000
Start time
15-22 RMON Configuration
(Optional) Displays the specified buffer control entry and all captured
packets associated with that entry.
(Optional) Displays only the buffer control entry specified by index.
Channel= 38283
avail FullAction
251 Capture slice
100 Download offset
Max Octet Granted
1 days 0 hours 51 minutes 15 seconds
EntryStatus= valid
lock
1518
0
50000
Refer to page...
15-22
15-23
15-24