Policy Capacities; A-2 Authentication Capacities - Enterasys SECURESTACK C3 Configuration Manual

Policy and Authentication Capacities
Table A-1 Policy Capacities (Continued)
Feature
1. These rules cannot be masked.
Authentication Capacities
Refer to the "Configuring User Authentication" Feature Guide for an in‐depth discussion of
authentication configuration. This Feature Guide is located on the Enterasys Networks web site:
http://www.enterasys.com/support/manuals/
Table A-2 Authentication Capacities
Authentication Feature
IEEE 802.1x (dot1x) authentication
MAC-based authentication
Port Web Authentication (PWA)
RFC 3580 dynamic VLAN assignment based on
authentication response
Multi-user authentication maximum users per port
when policy maptable response is:
User + IP phone
(Configured with a policy admin rule)
Multiauth numusers set to 2
A-2
udp dest port/udp source port
icmp type
policy mode
both, hybrid mode
tunnel mode
Capacity
cos/drop/fwd
1
Capacity
Supported
Supported
Supported
Supported, for 802.1x, MAC-based, and PWA
authentication methods
Supported
Authentication Capacities
No
3
3
6