sFlow Configuration
None.
Defaults
None.
Mode
Switch mode, read‐only.
Example
This example displays the output of this command. In this case, the IP address assigned to
loopback interface 1 will be used as the source IP address of the sFlow Agent.
C3(rw)->show sflow interface
loopback 1
clear sflow interface
Use this command to clear the management interface used by the sFlow Agent back to the default
of the Host VLAN.
Syntax
clear sflow interface
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This command returns the managment interface used by the sFlow Agent back to the default of
the Host VLAN.
C3(rw)->show sflow interface
vlan 100
C3(rw)->clear sflow interface
C3(rw)->
28-16
192.168.10.1
192.168.10.1
clear sflow interface