Setting Basic Switch Properties; Purpose; Commands - Enterasys SECURESTACK C3 Configuration Manual

Usage
Once a user account is locked out, it can only be re‐enabled by a super user with the set system
login command (page 3‐4).
If the default admin super user account has been locked out, you can wait until the lock out time
has expired or you can reset the switch in order to re‐enable the admin account.
Example
This example shows how to set login attempts to 5 and lockout time to 30 minutes:
C3(su)->set system lockout attempts 5 time 30

Setting Basic Switch Properties

Purpose

To display and set the system IP address and other basic system (switch) properties.

Commands

For information about...
show ip address
set ip address
clear ip address
show ip protocol
set ip protocol
show system
show system hardware
show system utilization
set system utilization
clear system utilization
show system enhancedbuffermode
set system enhancedbuffermode
set system temperature
clear system temperature
show time
set time
show summertime
set summertime
set summertime date
set summertime recurring
Setting Basic Switch Properties
Refer to page...
3-10
3-11
3-11
3-12
3-12
3-13
3-14
3-15
3-16
3-17
3-17
3-18
3-18
3-19
3-20
3-20
3-21
3-22
3-22
3-23
SecureStack C3 Configuration Guide 3-9