Clear Config - Enterasys SECURESTACK C3 Configuration Manual

Defaults
If no unit ID is specified, the entire system will be reset.
Mode
Switch command, read‐write.
Usage
A SecureStack C3 switch can also be reset with the RESET button located on its front panel. For
information on how to do this, refer to the SecureStack C3 Installation Guide shipped with your
switch.
Examples
This example shows how to reset the system:
C3(su)->reset
Are you sure you want to reload the stack? (y/n) y
Saving Configuration to stacking members
Reloading all switches.
This example shows how to reset unit 1:
C3(su)->reset 1
Are you sure you want to reload the switch? (y/n) y
Reloading switch 1.
This switch is manager of the stack.
STACK: detach 3 units

clear config

Use this command to clear the user‐defined configuration parameters.
Syntax
clear config [all]
Parameters
all
Defaults
If all is not specified, stacking configuration parameters will not be cleared.
Mode
Switch command, read‐write.
Usage
When using the clear config command to clear configuration parameters in a stack, it is important
to remember the following:
(Optional) Clears user‐defined configuration parameters (and stack unit
numbers and priorities, if applicable).
SecureStack C3 Configuration Guide 3-51
clear config