Set System Lockout; Show System Lockout Output Details - Enterasys SECURESTACK C3 Configuration Manual

set system lockout

Parameters
None.
Defaults
None.
Mode
Switch command, super user.
Example
This example shows how to display user lockout settings. In this case, switch defaults have not
been changed:
C3(su)->show system lockout
Lockout attempts: 3
Lockout time:
Table 3‐3 provides an explanation of the command output. These settings are configured with the
set system lockout command ("set system lockout" on page 3‐8).
Table 3-3 show system lockout Output Details
Output Field
Lockout attempts
Lockout time
set system lockout
Use this command to set the number of failed login attempts before locking out (disabling) a read‐
write or read‐only user account, and the number of minutes to lockout the default admin super
user account after maximum login attempts.
Syntax
set system lockout {[attempts attempts] [time time]}
Parameters
attempts attempts
time time
Defaults
None.
Mode
Switch command, super user.
3-8 Basic Configuration
15 minutes.
What It Displays...
Number of failed login attempts allowed before a read-write or read-only user's
account will be disabled.
Number of minutes the default admin user account will be locked out after the
maximum login attempts.
Specifies the number of failed login attempts allowed before a read‐write
or read‐only user's account will be disabled. Valid values are 1 to 10.
Specifies the number of minutes the default admin user account will be
locked out after the maximum login attempts. Valid values are 0 to 60.