Set Tacacs Server - Enterasys SECURESTACK C3 Configuration Manual

TACACS+ Configuration
Parameters
index
all
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example displays configuration information for TACACS+ server 1.
C3(ro)->show tacacs server 1
TACACS+ Server
--------------
1

set tacacs server

Use this command to configure the TACACS+ server(s) to be used by the TACACS+ client. You can
configure the timeout value for all configured servers or a single server, or you can configure the
IP address, TCP port, and secret for a single server. For simplicity, two syntax statements are
shown.
Syntax
set tacacs server {all | index} timeout seconds
set tacacs server index address port secret
Parameters
all
index
timeout seconds
address
port
secret
Defaults
No TACACS+ servers are configured by default.
When you do configure a TACACS+ server, the default timeout value is 10 seconds.
27-4
Display the configuration of the TACACS+ server identified by
The value of index
Display the configuration for all configured TACACS+ servers.
IP address Port
---------- ------
192.168.10.1 49
Specify the timeout value for all configured TACACS+ servers.
Configure the TACACS+ server identified by index. The value of index
can range from 1 to 2,147,483,647.
Set the timeout value for the specified server(s) in seconds. The value of
seconds can range from 1 to 180 seconds.
The default timeout value is 10 seconds.
Specify the IP address of the TACACS+ server.
Specify the TCP port for the TACACS+ server. The value of port can
range from 0 to 65535, but typically, port 49 is specified.
Specify the secret (shared password) for the TACACS+ server.
can range from 1 to 2,147,483,647.
Timeout
-------
10
set tacacs server
index .