Clear Snmp User; Show Snmp Group - Enterasys SECURESTACK C3 Configuration Manual

clear snmp user

Use this command to remove a user from the SNMPv3 security‐model list.
Syntax
clear snmp user user [remote remote]
Parameters
user
remote remote
Defaults
If remote is not specified, the user will be removed from the local SNMP engine.
Mode
Switch command, read‐write.
Example
This example shows how to remove the SNMP user named "bill":
C3(su)->clear snmp user bill

show snmp group

Use this command to display an SNMP group configuration. An SNMP group is a collection of
SNMPv3 users who share the same access privileges.
Syntax
show snmp group [groupname groupname] [user user] [security-model {v1 | v2c | usm}]
[volatile | nonvolatile | read-only]
Parameters
groupname
groupname
user user
security‐model v1 |
v2c | usm
volatile |
nonvolatile | read‐
only
Defaults
If groupname is not specified, information about all SNMP groups will be displayed.
If user is not specified, information about all SNMP users will be displayed.
If security‐model is not specified, user information about all SNMP versions will be displayed.
If not specified, information for all storage types will be displayed.
Specifies an SNMPv3 user to remove.
(Optional) Removes the user from a specific remote SNMP engine.
(Optional) Displays information for a specific SNMP group.
(Optional) Displays information about users within the specified group.
(Optional) Displays information about groups assigned to a specific
security SNMP model.
(Optional) Displays SNMP group information for a specified storage type.
clear snmp user
SecureStack C3 Configuration Guide 8-11