Ipv6 Enable - Enterasys SECURESTACK C3 Configuration Manual

This command also enables IPv6 processing on the interface and automatically generates a link‐
local address.
You can assign multiple globally reachable addresses to an interface with this command.
Use the no ipv6 address command without any parameters to remove all manually configured
IPv6 addresses from the interface.
Example
This example configures an IPv6 address by using the eui64 parameter. Then, the show ipv6
interface is executed to display the configuration. Note that a link‐local address has also
automatically been generated.
C3(su)->router(Config-if(Vlan 7))# ipv6 address 3FFE:501:FFFF:101/64 eui64
C3(su)->router>show ipv6 interface vlan 7
Vlan 7 Administrative Mode
Vlan 7 IPv6 Routing Operational Mode
IPv6 is
IPv6 Prefix is
Routing Mode
Interface Maximum Transmit Unit
Router Duplicate Address Detection Transmits
Router Advertisement NS Interval
Router Lifetime Interval
Router Advertisement Reachable Time
Router Advertisement Interval
Router Advertisement Managed Config Flag
Router Advertisement Other Config Flag
Router Advertisement Suppress Flag

ipv6 enable

This command enables IPv6 routing on an interface that has not been configured with an explicit
IPv6 address.
Syntax
ipv6 enable
no ipv6 enable
Parameters
None.
Defaults
IPv6 is disabled.
Mode
Router interface configuration: C3(su)‐>router(Config‐if(Vlan 1))#
Usage
When this command is executed, an IPv6 link‐local unicast address is configured on the interface
and IPv6 processing is enabled. You do not need to use this command if you configured an IPv6
global address on an interface with the ipv6 address command.
Enabled
Enabled
Enabled
FE80::211:88FF:FE55:4A7F/128
3FFE:501:FFFF:101:211:88FF:FE55:4A7F/64
Enabled
1500
1
0
1800
0
600
Disabled
Disabled
Disabled
SecureStack C3 Configuration Guide 22-11
ipv6 enable