Show License; Clear License - Enterasys SECURESTACK C3 Configuration Manual

show license

show license
Use this command to display license key information for switches with activated licenses.
Syntax
show license [unit number]
Parameters
unit number
Defaults
If no unit number is specified, license key information for all switches in the stack is displayed.
Mode
Switch command, read‐only.
Usage
Licenses can be displayed, applied, and cleared only with the license commands described in this
chapter. General configuration commands such as show config or clear config do not affect
licenses.
Example
This example shows how to display license key information for switch unit 1 in the stack.
C3(ro)->show license unit 1
unit 1
key: INCREMENT advrouter 2006.0728 permanent 31173CAC6495 045100039001
status: Active

clear license

Use this command to clear the license key settings..
Syntax
clear license featureId feature
Parameters
featureID feature
Defaults
None.
Mode
Switch command, read‐write.
4-4 Activating Licensed Features
(Optional) Specifies the switch for which to display license information.
Refer to Chapter 2, Configuring Switches in a Stack, for more
information about stack unit IDs, or numbers.
The name of the feature being cleared.