Usage
DHCPv6 pools are used to specify information for the DHCPv6 server to distribute to DHCPv6
clients. These pools are shared between multiple interfaces over which DHCPv6 server
capabilities are configured.
After executing this command and entering pool configuration mode, you can return to global
configuration mode by executing the exit command. Pool configuration commands are described
in the section "Address Pool Configuration Commands" on page 24‐6.
Use the no form of this command to remove a specified pool.
Example
This example enters DHCP pool configuration mode to configure the pool named "PoolA."
C3(su)->router(Config)# ipv6 dhcp pool PoolA
C3(su)->router(Config-dhcp6s-pool)#
ipv6 dhcp pool
SecureStack C3 Configuration Guide 24-5