show policy maptable
If VLAN authorization is not enabled, the tunnel attributes are ignored.
When Policy Maptable Response is "Policy"
When the switch is configured to use only Filter‐ID attributes, by setting the set policy maptable
command response parameter to policy:
•
If the Filter‐ID attributes are present, the specified policy profile will be applied to the
authenticating user. If no Filter‐ID attributes are present, or if the policy ID is unknown or
invalid, the default policy (if it exists) will be applied.
•
If the tunnel attributes are present, they are ignored. No VLAN‐to‐policy mapping will occur.
On switches that support policy, the default maptable response mode is policy. On switches that
do not support policy, the default maptable response mode is tunnel.
When Policy Maptable Response is "Tunnel"
When the switch is configured to use only tunnel attributes, by setting the set policy maptable
command response parameter to tunnel, and if VLAN authorization is enabled both globally and
on the authenticating user's port:
•
If the tunnel attributes are present, the specified VLAN will be applied to the authenticating
user. No VLAN‐to‐policy mapping will occur.
•
If the tunnel attributes are not present, the default policy VLAN will be applied if it exists.
Otherwise, the port VLAN will be applied.
•
If the Filter‐ID attributes are present, they are ignored.
If VLAN authorization is not enabled, the user will be allowed onto the port with the default
policy, if it exists. If no default policy exists, the port VLAN will be applied.
On switches that support policy, the default maptable response mode is policy. On switches that
do not support policy, the default maptable response mode is tunnel.
Commands
For information about...
show policy maptable
set policy maptable
clear policy maptable
show policy maptable
Use this command to display information about the current VLAN‐to‐policy mapping table and
the switch's policy maptable response setting.
Syntax
show policy maptable [vlan-list]
Parameters
vlan‐list
26-54 Authentication and Authorization Configuration
(Optional) Specifies the VLAN or list of VLANs for which to display the
VLAN‐to‐policy settings.
Refer to page...
26-54
26-55
26-56