Clear Dhcp Pool Client-Identifier - Enterasys SECURESTACK C3 Configuration Manual

clear dhcp pool client-identifier

Parameters
poolname
id
Defaults
None.
Mode
Switch command, read‐write.
Usage
The client identifier is formed by concatenating the media type and the MAC address. For
example, if the client hardware type is Ethernet and the client MAC address is 00:01:22:33:44:55,
then the client identifier configured with this command must be 01:00:01:22:33:44:55.
Example
This example shows how to configure the minimum requirements for a manual binding address
pool, using a client identifier rather than the hardware address of the client's hardware platform.
C3(rw)->set dhcp pool manual2 client-identifier 01:00:01:22:33:44:55
C3(rw)->set dhcp pool manual2 host 10.12.1.10 255.255.255.0
clear dhcp pool client-identifier
Use this command to remove the unique identifier of a DHCP client from a manual binding
address pool.
Syntax
clear dhcp pool poolname client-identifier
Parameters
poolname
Defaults
None.
Mode
Switch command, read‐write.
Example
This example deletes the client identifier from the address pool named "manual1."
C3(rw)->clear dhcp pool manual1 client-identifier
16-18 DHCP Server Configuration
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
Specifies the unique client identifier for this client. The value must be
entered in xx:xx:xx:xx:xx:xx format.
Specifies the name of the address pool. Pool names may be up to 31
characters in length.