Set Igmpsnooping Maxresponse - Enterasys SECURESTACK C3 Configuration Manual

Stackable switches

Hide thumbs Also See for SECURESTACK C3:

Table of Contents

Switch command, read‐write.

The IGMP group membership interval time sets the frequency of host‐query frame transmissions

and must be greater than the IGMP maximum response time as described in "set igmpsnooping

maxresponse" on page 13‐5.

This example shows how to set the IGMP group membership interval to 250 seconds:

C3(su)->set igmpsnooping groupmembershipinterval 250

set igmpsnooping maxresponse

Use this command to configure the IGMP query maximum response time for the system.

set igmpsnooping maxresponse time

Switch command, read‐write.

This value must be less than the IGMP maximum response time described in "set igmpsnooping

groupmembershipinterval" on page 13‐4.

Specifies the IGMP group membership interval. Valid values are 2 ‐ 3600

This value works together with the set igmpsnooping maxresponsetime

command to remove ports from an IGMP group and must be greater than

the max response time value.

Specifies the IGMP maximum query response time. Valid values are 100 ‐

255 seconds. The default value is 100 seconds.

This value works together with the set igmpsnooping

groupmembershipinterval command to remove ports from an IGMP group

and must be lesser than the group membership interval value.

set igmpsnooping maxresponse

SecureStack C3 Configuration Guide 13-5

Show Quick Links

Table of Contents

Do you have a question about the SECURESTACK C3 and is the answer not in the manual?