Clear Sflow Port Poller; Set Sflow Port Sampler - Enterasys SECURESTACK C3 Configuration Manual

sFlow Configuration

clear sflow port poller

Use this command to change the poller interval or to remove poller instances.
Syntax
clear sflow port port-string poller [interval]
Parameters
port‐string
interval
Defaults
If interval is not specified, the poller instance is cleared.
Mode
Switch command, read‐write.
Example
This example removes the poller instance on port ge.1.1.
C3(su)->clear sflow port ge.1.1 poller

set sflow port sampler

Use this command to configure sampler instances on ports, or data sources.
Syntax
set sflow port port-string sampler {index | maxheadersize bytes | rate rate}
Parameters
port‐string
index
maxheadersize bytes
rate rate
28-12
Specifies the port or ports on which the poller instance is being cleared.
(Optional) Specifies that the polling interval should be cleared to 0. A
value of 0 disables counter sampling.
Specifies the port or ports (data sources) on which the sampler instance
is being configured.
Index number in the sFlow Receivers Table for the receiver/Collector
with which the sampler instance is associated. The index can range from
1 to 8.
Specifies the maximum number of bytes that should be copied from the
sampler packet. The value can range from 20 to 256 bytes. The default is
128 bytes.
Specifies the statistical sampling rate for sampling from this data
source. The value of rate specifies the number of incoming packets from
which one packet will be sampled. For example, if the rate is 1024, one
packet will be sampled from every 1024 ingressing packets on this data
source.
The rate can range from 1024 to 65536. A value of 0 disables sampling.
The default value is 0.
clear sflow port poller