Show Config - Enterasys SECURESTACK C3 Configuration Manual

Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display a text file named "myconfig" in the configs/ directory. Note
that only a portion of the file is shown in this example.
C3(rw)->show file configs/myconfig
...
17 : #snmp
18 :
19 : set snmp access ro security-model v1 exact read All notify All nonvolatile
20 :
21 : set snmp access ro security-model v2c exact read All notify All nonvolatile
22 :
23 : set snmp access public security-model v1 exact read All write All notify All
nonvolatile
24 :
25 : set snmp access public security-model v2c exact read All write All notify All
nonvolatile
26 :
27 : set snmp access public security-model usm exact read All write All notify All
nonvolatile
28 :
29 : set snmp community :xxxxxxxxxxx:
30 :
31 : set snmp group ro user ro security-model v1
32 :
33 : set snmp group public user public security-model v1
34 :
35 : set snmp group ro user ro security-model v2c
36 :
37 : set snmp group public user public security-model v2c
38 :
39 : set snmp group public user public security-model usm
40 :
41 : set snmp user public authentication md5 :xxxxxxxxx: encryption des privacy
:xxxxxxxxxx:
42 :
43 : set snmp view viewname All subtree 1
44 :
45 : !

show config

Use this command to display the system configuration or write the configuration to a file.
Syntax
show config [all | facility] [outfile {configs/filename}]
SecureStack C3 Configuration Guide 3-43
show config