Clear Snmp Interface - Enterasys SECURESTACK C3 Configuration Manual

Example
This example configures an IP address on VLAN interface 100 and then sets that interface as the
SNMP agent source IP address.
C3(rw)->router(Config-if(Vlan 100))#ip address 192.168.10.1 255.255.255.0
C3(rw)->router(Config-if(Vlan 100))#exit
C3(rw)->router(Config)#exit
C3(rw)->router#exit
C3(rw)->router>exit
C3(rw)->set snmp interface vlan 100
C3(rw)->show snmp interface
vlan 100

clear snmp interface

Use this command to clear the interface used for the source IP address of the SNMP agent back to
the default of the Host interface.
Syntax
clear snmp interface
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This command returns the interface used for the source IP address of the SNMP agent back to the
default of the Host interface.
C3(rw)->show snmp interface
vlan 100
C3(rw)->clear snmp interface
C3(rw)->
192.168.10.1
192.168.10.1
clear snmp interface
SecureStack C3 Configuration Guide 8-41