Traceroute Ipv6 - Enterasys SECURESTACK C3 Configuration Manual

traceroute ipv6

ipv6‐addr
size num
Defaults
None.
Mode
Router privileged exec: C3(su)‐>router#
Usage
Use this command to ping an interface by using the link‐local address or the global IPv6 address
of the interface. You can use a loopback, tunnel, or logical interface as the source. The source and
target devices must have the ping utility enabled and running on top of TCP/IP.
The switch can be pinged from any IP workstation with which the switch is connected through the
default VLAN (VLAN 1), as long as there is a physical path between the switch and the
workstation. The terminal interface sends three pings to the target station.
Example
This example shows output from a successful ping to link‐local address fe80::211:88ff:fe55:4a7f.
C3(su)->router#ping ipv6 interface vlan 6 link-local-address
fe80::211:88ff:fe55:4a7f
Send count=3, Receive count=3 from fe80::211:88ff:fe55:4a7f
Average round trip time = 1.00 ms
traceroute ipv6
Use this command to discover the routes that packets actually take when traveling to their
destination through the network on a hop‐by‐hop basis.
Syntax
traceroute ipv6 ipv6-addr
Parameters
ipv6‐addr
Defaults
None.
Mode
Router privileged exec: C3 (su)‐>router#
22-8 IPv6 Configuration
Specifies the global IPv6 address of the system to ping. Enter the address
in the form documented in RFC 4291, with the address specified in
hexadecimal using 16‐bit values between colons.
(Optional) Specifies the size of the datagram packet. The value of num can
range from 48 to 2048 bytes.
Specifies a host to which the route of an IPv6 packet will be traced. Enter the
address in the form documented in RFC 4291, with the address specified in
hexadecimal using 16‐bit values between colons.