Ip Pimsm; Ip Pimsm Staticrp - Enterasys SECURESTACK C3 Configuration Manual

ip pimsm

For information about...
Display commands
show ip pimsm
show ip pimsm componenttable
show ip pimsm interface
show ip pimsm neighbor
show ip pimsm rp
show ip pimsm rphash
show ip pimsm staticrp
show ip mroute
ip pimsm
This command sets administrative mode of PIM‐SM multicast routing across the router to
enabled. IGMP must be enabled before PIM‐SM can be enabled. By default, both IGMP and PIM
are globally disabled. The no form of this command disables PIM‐SM (across the entire stack, if
applicable).
Syntax
ip pimsm
no ip pimsm
Parameters
None.
Defaults
None.
Mode
Global router configuration: C3(su)‐>router(Config)#
Example
This example shows how to globally enable and disable PIM:
C3(su)->router(Config)# ip pimsm
C3(su)->router(Config)# no ip pimsm

ip pimsm staticrp

This command is used to create a manual Rendezvous Point IP address for the PIM‐SM router.
The no form of this command removes a previously configured RP.
Syntax
ip pimsm staticrp ipaddress groupadress groupmask
no ip pimsm staticrp ipaddress groupadress groupmask
20-50 IPv4 Routing Protocol Configuration
Refer to page...
20-52
20-53
20-54
20-55
20-56
20-57
20-58
20-59