Configuring Quality Of Service (Qos); Purpose; Commands; Show Port Txq - Enterasys SECURESTACK C3 Configuration Manual

Configuring Quality of Service (QoS)

Refer to the "Configuring QoS" Feature Guide for detailed information about configuring quality
of service on the SecureStack C3. The Enterasys Networks firmware Feature Guides are available
at:
http://www.enterasys.com/support/manuals

Purpose

Eight transmit queues are implemented in the switch hardware for each port. The commands in
this section allow you to set the priority mode and weight for each of the available queues (0
through 7) for each physical port on the switch. Priority mode and weight cannot be configured on
LAGs, only on the physical ports that make up the LAG.

Commands

For information about...

show port txq

set port txq
clear port txq
show port txq
Use this command to display QoS transmit queue information for one or more physical ports.
Syntax
show port txq [port-string]
Parameters
port‐string
Defaults
If the port‐string is not specified, the QoS setting of all physical ports will be displayed.
Mode
Switch command, read‐only.
(Optional) Specifies port(s) for which to display QoS settings. For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 7‐1.
Only physical ports will be displayed. LAG ports have no transmit queue
information.
Configuring Quality of Service (QoS)
Refer to page...
12-7
12-8
12-9
SecureStack C3 Configuration Guide 12-7