Area Virtual-Link Hello-Interval; Area Virtual-Link Retransmit-Interval - Enterasys SECURESTACK C3 Configuration Manual

area virtual-link hello-interval

This command configures the hello interval for the specified OSPFv3 virtual interface.
Syntax
area areaid virtual-link neighborid hello-interval seconds
no area areaid virtual-link neighborid hello-interval
Parameters
areaid
neighborid
seconds
Defaults
The default hello interval is 10 seconds.
Mode
Router OSPFv3 configuration: C3(su)‐>router(Config‐router)#
Usage
Use the no form of this command to return a configured value to the default value of 10 seconds.
Example
This example configures a hello interval of 30 seconds for the specified OSPFv3 virtual interface.
C3(su)->router(Config-router)# area 20 virtual-link 2.2.2.2 hello-interval 30

area virtual-link retransmit-interval

This command configures the retransmit interval for the specified OSPFv3 virtual interface.
Syntax
area areaid virtual-link neighborid retransmit-interval seconds
no area areaid virtual-link neighborid retransmit-interval
Parameters
areaid
neighborid
seconds
Specifies the area ID in IP address format (dotted‐quad) or as a decimal
value.
Specifies the virtual link neighbor by means of its router ID. The router
ID must be entered in 32‐bit dotted‐quad notation.
Specifies the value of the hello interval in seconds. The range is from 1
to 65535 seconds.
Specifies the area ID in IP address format (dotted‐quad) or as a decimal
value.
Specifies the virtual link neighbor by means of its router ID. The router
ID must be entered in 32‐bit dotted‐quad notation.
Specifies the value of the retransmit interval in seconds. The range is
from 1 to 3600 seconds.
area virtual-link hello-interval
SecureStack C3 Configuration Guide 25-19