Set Boot System - Enterasys SECURESTACK C3 Configuration Manual

set boot system

set boot system
Use this command to set the firmware image the switch loads at startup.
Syntax
set boot system filename
Parameters
filename
Defaults
None.
Mode
Switch command, read‐write.
Usage
This command allows you to set the firmware image to be loaded at startup. You can choose to
reset the system to use the new firmware image immediately, or you can choose to only specify the
new image to be loaded the next time the switch is rebooted.
You can use the dir command to display the "Active" image and the "Boot" image, which will be
the image loaded at the next system reboot.
Example
This example shows how to set the boot firmware image file to be used at the next reboot of the
system, by answering "n" to the prompt. The dir command is then executed to display the Active
and Boot images.
C3(su)->set boot system c3_06.03.03.0007
This command can optionally reset the system to boot the new image.
Do you want to reset now (y/n) [n]?n
C3(su)->dir
Images:
==================================================================
Filename:
Version:
Size:
Date:
CheckSum:
Compatibility: <platform specific>
Filename:
Version:
Size:
Date:
CheckSum:
Compatibility: <platform specific>
3-36 Basic Configuration
Specifies the name of the firmware image file.
Note: If you are changing the firmware image to a version earlier than the current version, refer to
"Reverting to a Previous Image" on page 3-34 for the correct steps to follow.
c3_06.03.00.0026 (Active)
06.03.00.0026
9405440 (bytes)
Fri Jul 18 12:48:35 2008
f1626ccf10d8f48cd6c3e79ab602342a
c3_06.03.03.0007 (Boot)
06.03.03.0007
8290304 (bytes)
Fri May
9f820d79239f10890442f8ff1f2bc914
9 11:35:27 2008