Table 14-1 show logging server Output Details
Output Field
IP Address
Facility
Severity
Description
Port
Status
set logging server
Use this command to configure a Syslog server.
Syntax
set logging server index [ip-addr ip-addr] [facility facility] [severity severity]
[descr descr] [port port] [state {enable | disable}]
Parameters
index
ip‐addr ip‐addr
facility facility
severity severity
descr descr
port port
state enable |
disable
What It Displays...
Syslog server's IP address. For details on setting this using the set logging server
command, refer to
"set logging
Syslog facility that will be encoded in messages sent to this server. Valid values are:
local0 to local7.
Severity level at which the server is logging messages.
Text string description of this facility/server.
UDP port the client uses to send to the server.
Whether or not this Syslog configuration is currently enabled or disabled.
Specifies the server table index number for this server. Valid values are 1 ‐
8.
(Optional) Specifies the Syslog message server's IP address.
(Optional) Specifies the server's facility name. Valid values are: local0 to
local7.
(Optional) Specifies the severity level at which the server will log
messages. Valid values and corresponding levels are:
1 — emergencies (system is unusable)
2 — alerts (immediate action required)
3 — critical conditions
4 — error conditions
5 — warning conditions
6 — notifications (significant conditions)
7 — informational messages
8 — debugging messages
(Optional) Specifies a textual string description of this facility/server.
(Optional) Specifies the default UDP port the client uses to send to the
server.
(Optional) Enables or disables this facility/server configuration.
server" on page 14-3.
SecureStack C3 Configuration Guide 14-3
set logging server