Show Ipv6 Ospf Stub Table; Show Ipv6 Ospf Range Output Details; Show Ipv6 Ospf Stub Table Output Details - Enterasys SECURESTACK C3 Configuration Manual

Table 25-11 show ipv6 ospf range Output Details
Output Field
Area ID
IPv6 Prefix/Prefix Length
Lsdb Type
Advertisement

show ipv6 ospf stub table

This command displays the OSPFv3 stub table, if OSPFv3 is initialized on the switch.
Syntax
show ipv6 ospf stub table
Parameters
None.
Defaults
None.
Mode
Router privileged execution: C3(su)‐>router#
Example
This example displays the OSPFv3 stub table information.
C3(su)->router# show ipv6 ospf stub table
AreaId
---------------- ------------- ---------- -----------------
0.0.0.20
Table 25‐12 provides an explanation of the command output.
Table 25-12 show ipv6 ospf stub table Output Details
Output Field
Area ID
Type of Service
Metric Val
Import Summary LSA
What It Displays...
The area ID of the requested OSPFv3 area.
An IPv6 prefix and length which represents a configured area
range.
The type of link advertisement associated with this area range.
The status of the advertisement: enabled or disabled.
TypeofService Metric Val Import SummaryLSA
Normal 1
What It Displays...
A 32-bit identifier for the created stub area.
Type of service associated with the stub metric. For this release,
Normal TOS is the only supported type.
The metric value is applied based on the TOS. It defaults to the
least metric of the type of service among the interfaces to other
areas. The OSPFv3 cost for a route is a function of the metric
value.
Controls the import of summary LSAs into stub areas.
Enable
SecureStack C3 Configuration Guide 25-45
show ipv6 ospf stub table