Clear Snmp Targetaddr - Enterasys SECURESTACK C3 Configuration Manual

clear snmp targetaddr

taglist taglist
volatile |
nonvolatile
Defaults
If not specified, udpport will be set to 162.
If not specified, mask will be set to 255.255.255.255
If not specified, timeout will be set to 1500.
If not specified, number of retries will be set to 3.
If taglist is not specified, none will be set.
If not specified, storage type will be nonvolatile.
Mode
Switch command, read‐write.
Example
This example shows how to configure a trap notification called "TrapSink." This trap notification
will be sent to the workstation 192.168.190.80 (which is target address "tr"). It will use security
and authorization criteria contained in a target parameters entry called "v2cExampleParams". For
more information on configuring a basic SNMP trap, refer to "Creating a Basic SNMP Trap
Configuration" on page 8‐37:
C3(su)->set snmp targetaddr tr 192.168.190.80 param v2cExampleParams taglist
TrapSink
clear snmp targetaddr
Use this command to delete an SNMP target address entry.
Syntax
clear snmp targetaddr targetAddr
Parameters
targetAddr
Defaults
None.
Mode
Switch command, read‐write.
8-28 SNMP Configuration
(Optional) Specifies a list of SNMP notify tag values. This tags a location
to the target address as a place to send notifications. List must be enclosed
in quotes and tag values must be separated by a space (for example,
"tag 1 tag 2").
(Optional) Specifies temporary (default), or permanent storage for SNMP
entries.
Specifies the target address entry to delete.