Show Ipv6 Ospf Virtual-Link; Show Ipv6 Ospf Virtual-Link Output Details - Enterasys SECURESTACK C3 Configuration Manual

show ipv6 ospf virtual-link

show ipv6 ospf virtual-link
This command displays the OSPFv3 virtual interface information for a specific area and neighbor.
Syntax
show ipv6 ospf virtual-link areaid neighborid
Parameters
areaid
neighborid
Defaults
None.
Mode
Router privileged execution: C3(su)‐>router#
Example
This information displays virtual link information for area ID 10 and the neighbor with router ID
of 3.3.3.3.
C3(su)->router(Config)#show ipv6 ospf virtual-link 10 3.3.3.3
Area ID
Neighbor IP Address
Hello Interval
Dead Interval
Iftransit Delay Interval
Retransmit Interval
State
Metric
Neighbor State
Table 25‐13 provides an explanation of the command output.
Table 25-13 show ipv6 ospf virtual-link Output Details
Output Field
Area ID
Neighbor Router ID
Hello Interval
Dead Interval
Iftransit Delay Interval
Retransmit Interval
State
25-46 OSPFv3 Configuration
Specifies the area ID in IP address format (dotted‐quad) or as a decimal
value.
Specifies the neighbor by its router ID, specified in 32‐bit dotted quad
format.
What It Displays...
The area id of the requested OSPFv3 area.
The input neighbor Router ID.
The configured hello interval for the OSPFv3 virtual interface.
The configured dead interval for the OSPFv3 virtual interface.
The configured transit delay for the OSPFv3 virtual interface.
The configured retransmit interval for the OSPFv3 virtual
interface.
The OSPFv3 Interface States are: down, loopback, waiting, point-
to-point, designated router, and backup designated router. This is
the state of the OSPFv3 interface.
10
3.3.3.3
10
40
1
5
DOWN
0
DOWN