Set Password - Enterasys SECURESTACK C3 Configuration Manual

Parameters
username
Defaults
None.
Mode
Switch command, super user.
Example
This example shows how to remove the "netops" user account:
C3(su)->clear system login netops

set password

Use this command to change system default passwords or to set a new login password on the CLI.
Syntax
set password [username]
Parameters
username
Defaults
None.
Mode
Switch command, read‐write.
Switch command, super‐user.
Usage
Read‐Write users can change their own passwords.
Super Users (Admin) can change any password on the system.
If you forget the password for the admin user account, you can reset the password to the default
password value by pressing the password reset button on the switch.
Specifies the login name of the account to be cleared.
Note: The default admin (su) account cannot be deleted.
(Only available to users with super‐user access.) Specifies a system default
or a user‐configured login account name. By default, the SecureStack C3
switch provides the following account names:
ro for Read‐Only access.
rw for Read‐Write access.
admin for Super User access. (This access level allows Read‐Write access
to all modifiable parameters, including user accounts.)
set password
SecureStack C3 Configuration Guide 3-5