Set Macauthentication Portinitialize; Set Macauthentication Portquietperiod - Enterasys SECURESTACK C3 Configuration Manual

set macauthentication portinitialize

Usage
Enabling port(s) for MAC authentication requires globally enabling MAC authentication on the
switch as described in "set macauthentication" on page 26‐28, and then enabling it on a port‐by‐
port basis. By default, MAC authentication is globally disabled and disabled on all ports.
Example
This example shows how to enable MAC authentication on
C3(su)->set macauthentication port enable ge.2.1-5
set macauthentication portinitialize
Use this command to force one or more MAC authentication ports to re‐initialize and remove any
currently active sessions on those ports.
Syntax
set macauthentication portinitialize port-string
Parameters
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to force
C3(su)->set macauthentication portinitialize ge.2.1-5

set macauthentication portquietperiod

This sets the number of seconds following a failed authentication before another attempt may be
made on the port.
Syntax
set macauthentication portquietperiod time port-string
Parameters
time
port‐string
26-30 Authentication and Authorization Configuration
Specifies the MAC authentication port(s) to re‐initialize. For a detailed
description of possible port‐string values, refer to "Port String Syntax Used
in the CLI" on page 7‐1.
.2.1 through 5 to initialize:
ge
Period in seconds to wait after a failed authentication. By default, this is 30
seconds.
Specifies the ports for which the quit period is to be applied. For a detailed
description of possible port‐string values, refer to "Port String Syntax Used
in the CLI" on page 7‐1.
.2.1 though 5:
ge