Show Lldp Port Local-Info - Enterasys SECURESTACK C3 Configuration Manual

show lldp port local-info

Parameters
port‐string
Defaults
If port‐string is not specified, port location configuration information will be displayed for all
ports.
Mode
Switch command, read‐only.
Example
This example shows how to display port location information for three ports.
C3(ro)->show lldp port location-info ge.1.1-3
Ports
--------
ge.1.1
ge.1.2
ge.1.3
show lldp port local-info
Use this command to display the local system information stored for one or more ports. You can
use this information to detect misconfigurations or incompatibilities between the local port and
the attached endpoint device (remote port).
Syntax
show lldp port local-info [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, local system information will be displayed for all ports.
Mode
Switch command, read‐only.
Example
This example shows how to display the local system information stored for port ge.4.1. Table
describes the output fields of this command.
C3(rw)->show lldp port local-info
Local Port
--------------------
Port Desc
6-18 Discovery Protocol Configuration
(Optional) Displays port location information for one or a range of
ports.
Type Location
------------- -------------------------
ELIN 1234567890
ELIN 1234567890
ELIN 1234567890
(Optional) Displays local system information for one or a range of
ports.
ge.
: 4.1 Local Port Id:
: ... 1000BASE-TX RJ45 Gigabit Ethernet Frontpanel Port
ge.
4.1
ge.
4.1
6‐4