Set Multiauth Mode; Clear Multiauth Mode - Enterasys SECURESTACK C3 Configuration Manual

set multiauth mode

Use this command to set the system authentication mode to allow multiple authenticators
simultaneously (802.1x, PWA, and MAC Authentication) on a single port, or to strictly adhere to
802.1x authentication.
Syntax
set multiauth mode {multi | strict}
Parameters
multi
strict
Defaults
None.
Mode
Switch command, read‐write.
Usage
Multiauth multi mode requires that MAC, PWA, and 802.1X authentication be enabled globally,
and configured appropriately on the desired ports according to their corresponding command
sets described in this chapter. Refer to "Configuring 802.1X Authentication" on page 26‐15 and
"Configuring MAC Authentication" on page
(PWA)" on page 26‐68.
Example
This example shows how to enable simultaneous multiple authentications:
C3(rw)->set multiauth mode multi

clear multiauth mode

Use this command to clear the system authentication mode.
Syntax
clear multiauth mode
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Allows the system to use multiple authenticators simultaneously (802.1x,
PWA, and MAC Authentication) on a port. This is the default mode.
User must authenticate using 802.1x authentication before normal traffic
(anything other than authentication traffic) can be forwarded.
26‐25 and "Configuring Port Web Authentication
SecureStack C3 Configuration Guide 26-39
set multiauth mode