History Group Commands; Show Rmon History - Enterasys SECURESTACK C3 Configuration Manual

History Group Commands

History Group Commands
Purpose
To display, configure, and clear RMON history properties and statistics.
Commands
For information about...

show rmon history

set rmon history
clear rmon history
show rmon history
Use this command to display RMON history properties and statistics. The RMON history group
records periodic statistical samples from a network.
Syntax
show rmon history [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, information about all RMON history entries will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display RMON history entries for Gigabit Ethernet port 1 in switch 1.
A control entry displays first, followed by actual entries corresponding to the control entry. In this
case, the default settings for entry owner, sampling interval, and maximum number of entries.
(buckets) have not been changed from their default values. For a description of the types of
statistics shown, refer to Table
:
C3(su)->show rmon history ge.1.1
Port: ge.1.1
-------------------------------------
Index 1
Owner
Status
Data Source
Interval
Buckets Requested = 50
Buckets Granted
15-6 RMON Configuration
(Optional) Displays RMON history entries for specific port(s).
15‐2.
= monitor
= valid
= ifIndex.1
= 30
= 10
Refer to page...
15-6
15-7
15-7