Configuring Igmp On Routing Interfaces - Enterasys SECURESTACK C3 Configuration Manual

Configuring IGMP on Routing Interfaces

Configuring IGMP on Routing Interfaces
Purpose
To configure IGMP on routing interfaces.
Commands
For information about...
ip igmp
ip igmp enable
ip igmp version
show ip igmp interface
show ip igmp groups
ip igmp query-interval
ip igmp query-max-response-time
ip igmp startup-query-interval
ip igmp startup-query-count
ip igmp last-member-query-interval
ip igmp last-member-query-count
ip igmp robustness
ip igmp
Use this command to enable the L3 IGMP Querier functionality on the switch. The no form of this
command disables IGMP Querier functionality.
Syntax
ip igmp
no ip igmp
Parameters
None.
Defaults
None.
Mode
Global configuration: C3(su)‐>router(Config)#
13-10 IGMP Configuration
Router: The commands covered in this section can be executed only when the device is in router
mode. For details on how to enable router configuration modes, refer to
Configuration Modes" on page 18-2.
"Enabling Router
Refer to page...
13-10
13-11
13-11
13-12
13-13
13-13
13-14
13-14
13-15
13-15
13-16
13-16