Commands; Ipv6 Proxy-Routing; Show Ipv6 Proxy-Routing - Enterasys SECURESTACK C3 Configuration Manual

Commands

For information about...

ipv6 proxy-routing

show ipv6 proxy-routing

ipv6 proxy-routing
Use this command to enable or disable IPv6 proxy routing on a mixed C2/C3 stack.
Syntax
ipv6 proxy-routing
no ipv6 proxy-routing
Parameters
None.
Defaults
IPv6 proxy routing is disabled by default.
Mode
Router global configuration: C2(su)‐>router(Config)#
Usage
IPv6 proxy routing is disabled by default. It must be enabled with this command before the C2
switches in the stack will start redirecting routed IPv6/tunneling packets to the C3 proxy server.
Uses the no form of this command to disable IPv6 proxy routing.
Example
This example enables IPv6 proxy routing.
c2(su)->router
c2(su)->router>enable
c2(su)->router#config
Enter configuration commands:
c2(su)->router(Config)#ipv6 proxy-routing
show ipv6 proxy-routing
Use this command to display the status of IPv6 proxy routing.
Syntax
show ipv6 proxy-routing
Parameters
None.
Refer to page...
23-3
23-3
SecureStack C3 Configuration Guide 23-3
Commands