Reviewing And Selecting A Boot Firmware Image; Purpose; Commands; Show Boot System - Enterasys SECURESTACK C3 Configuration Manual

7. Reboot the system using the reset command (page 3‐50).

Reviewing and Selecting a Boot Firmware Image

Purpose

To display and set the image file the switch loads at startup. The C3 switch allows you to
download and store a backup image, which can be selected as the startup image by using the
commands described in this section.

Commands

For information about...

show boot system

set boot system
show boot system
Use this command to display the firmware image the switch loads at startup.
Syntax
show boot system
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the switch's boot firmware image:
C3(su)->show boot system
Current system image to boot: bootfile
Caution: If you do not follow the steps above, you may lose remote connectivity to the switch.
Reviewing and Selecting a Boot Firmware Image
Refer to page...
3-35
3-36
SecureStack C3 Configuration Guide 3-35