DHCPv6 Show Commands
Purpose
These commands are used to display DHCPv6 configuration information and statistics, to clear
statistics globally or for a specific interface, and to display address pool and binding information.
Commands
For information about...
show ipv6 dhcp
show ipv6 dhcp interface
show ipv6 dhcp statistics
clear ipv6 dhcp statistics
show ipv6 dhcp pool
show ipv6 dhcp binding
show ipv6 dhcp
This command displays the state of DHCPv6 on the switch and, if DHCPv6 is enabled, the
switch's DHCP unique identifier (DUID).
Syntax
show ipv6 dhcp
Parameters
None.
Defaults
None.
Mode
Router privileged execution: C3(su)‐>router#
Example
This example illustrates the output of this command when DHCPv6 is enabled on the switch.
C3(su)->router# show ipv6 dhcp
DHCPv6 is enabled
Server DUID: 00:01:00:06:90:83:57:c7:00:11:88:56:5d:58
DHCPv6 Show Commands
Refer to page...
24-13
24-14
24-16
24-17
24-18
24-18
SecureStack C3 Configuration Guide 24-13