Ipv6 Nd Dad Attempts; Ipv6 Nd Ns-Interval - Enterasys SECURESTACK C3 Configuration Manual

Stackable switches
Hide thumbs Also See for SECURESTACK C3:
Table of Contents

Advertisement

ipv6 nd dad attempts

This command configures the number of duplicate address detection (DAD) attempts made on the 
interface when configuring IPv6 unicast addresses.
Syntax
ipv6 nd dad attempts number
no ipv6 nd dad attempts
Parameters
number
Defaults
Duplicate address detection enabled, for 1 attempt.
Mode
Router interface configuration: C3(su)‐>router(Config‐if(Vlan 1))#
Usage
IPv6 Duplicate Address Detection is described in RFC 2462. Duplicate Address Detection uses 
Neighbor Solicitation and Neighbor Advertisement messages to verify the uniqueness of an 
address. Duplicate Address Detection must be performed on unicast addresses prior to assigning 
them to an interface. An address remains in a tentative state while Duplicate Address Detection is 
being performed. If a tentative address is found to be a duplicate, an error message is returned 
and the address is not assigned to the interface.
Use this command to change the number of Neighbor Solicitation messages that can be sent for 
Duplicate Address Detection from the default value of 1. The no form of the command returns the 
value to the default of 1. A value of 0 disables Duplicate Address Detection on the interface.
The show ipv6 interface command displays the current DAD attempt setting.
Example
This example changes the number of consecutive Neighbor Solicitation messages sent for DAD to 
3 on this interface.
C3(su)->router(Config-if(Vlan 1))# ipv6 nd dad attempts 3

ipv6 nd ns-interval

This command configures the interval between Neighbor Solicitations sent on an interface.
Syntax
ipv6 nd ns-interval {msec | 0}
no ipv6 nd ns-interval
Specifies the number of consecutive Neighbor Solicitation message 
transmitted on the interface, when Duplicate Address Detection (DAD) 
is performed on a unicast IPv6 address assigned to the interface. 
The value can range from 0 to 600. A value of 0 disables Duplicate 
Address Detection on the interface. A value of 1, which is the default, 
specifies a single transmission with no follow‐up transmissions.
ipv6 nd dad attempts
SecureStack C3 Configuration Guide 22-15

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents