Create - Enterasys SECURESTACK C3 Configuration Manual

Usage
You must execute the router vrrp command to enable the protocol before completing other
VRRP‐specific configuration tasks. For details on enabling configuration modes, refer to Table 18‐2
on page 18‐2.
Example
This example shows how enable VRRP configuration mode:
C3(su)->router#configure
C3(su)->router(Config)#router vrrp
C3(su)->router(Config-router)#

create

Use this command to create a VRRP session. Each SecureStack C3 system supports up to 20 VRRP
sessions. The no form of this command disables the VRRP session.
Syntax
create vlan vlan-id vrid
no create vlan vlan-id vrid
Parameters
vlan vlan‐id
vrid
Defaults
None.
Mode
Router configuration: C3(su)->router(Config-router)#
Usage
This command must be executed to create an instance of VRRP on a routing interface (VLAN)
before any other VRRP settings can be configured.
Example
This example shows how to create a VRRP session on the VLAN 1 interface with a VRID of 1:
C3(su)->router(Config)#router vrrp
C3(su)->router(Config-router)#create vlan 1 1
Specifies the number of the VLAN on which to create a VRRP session. This
VLAN must be configured for IP routing as described in "Pre‐Routing
Configuration Tasks" on page 18‐1.
Specifies a unique Virtual Router ID (VRID) to associate with the routing
interface.
SecureStack C3 Configuration Guide 20-43
create