Ip Pimsm Query-Interval; Show Ip Pimsm - Enterasys SECURESTACK C3 Configuration Manual

ip pimsm query-interval

ip pimsm query-interval
This command configures the transmission frequency of hello messages in seconds between
PIM‐enabled neighbors. The no form of this command resets the hello interval to the default, 30
seconds.
Syntax
ip pimsm query-interval seconds
no ip pimsm query-interval
Parameters
seconds
Defaults
None.
Mode
Interface configuration: C3
Example
This example shows how to set the hello interval rate to 100 seconds.
C3(su)->router(Config)#interface vlan 1
C3(su)->router(Config-if(Vlan 1))#ip pimsm query-interval 100

show ip pimsm

Use this command to display system‐wide PIM‐SM routing information.
Syntax
show ip pimsm
Parameters
None.
Defaults
None.
Mode
Any router mode.
Example
This example shows how to display PIM information.
C3(su)->router# show ip pimsm
Admin Mode Enable
Join/Prune Interval (secs) 60
20-52 IPv4 Routing Protocol Configuration
This field has a range of 10 to 3600 seconds. Default is 30.
(su)‐>router(Config‐if(Vlan 1))#