Set Ssl - Enterasys SECURESTACK C3 Configuration Manual

set ssl

Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display SSL status:
C3(rw)->show ssl
SSL status: Enabled
set ssl
Use this command to enable or disable the use of WebView over SSL port 443. By default, SSL is
disabled on the switch. This command can also be used to reinitialize the hostkey that is used for
encryption.
Syntax
set ssl {enabled | disabled | reinitialize | hostkey reinitialize}
Parameters
enabled | disabled
reinitialize
hostkey reinitialize
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to enable SSL:
C3(rw)->set ssl enabled
3-54 Basic Configuration
Enables or disables the ability to use WebView over SSL.
Stops and then restarts the SSL process.
Stops SSL, regenerates new keys, and then restarts SSL.