Setting User Accounts And Passwords; Purpose; Commands; Optional Cli Setup Commands - Enterasys SECURESTACK C3 Configuration Manual

Setting User Accounts and Passwords

Table 3-2 Optional CLI Setup Commands
Task
Save the active configuration.
Enable or disable SSH.
Enable or disable Telnet.
Enable or disable HTTP
management (WebView).
Enable or disable SNMP port link
traps.
Set the per port broadcast limit
Configure a VLAN.
Set a Syslog server IP and
severity
Configure and enable a RADIUS
server.
Setting User Accounts and Passwords

Purpose

To change the switch's default user login and password settings, and to add new user accounts
and passwords.

Commands

For information about...
show system login
set system login
clear system login
set password
set system password length
set system password aging
set system password history
show system lockout
set system lockout
3-2 Basic Configuration
CLI commands
save config
set ssh enable | disable
set telnet {enable | disable} [inbound |
outbound | all]
set webview {enable | disable}
set port trap port-string {enable | disable}
set port broadcast port-string threshold-value
set vlan create vlan-id
set port vlan port-string vlan-id modify-egress
set logging server index ip-addr ip-addr
severity severity state enable
set radius server index ip-addr
port [secret-value]{realm {management-access |
any | network-access}
set radius enable
Refer to
page...
3-41
26-77
3-37
3-53
7-25
7-34
10-5
10-9
10-9
26-7
26-7
Refer to page...
3-3
3-4
3-4
3-5
3-6
3-6
3-7
3-7
3-8