Set Summertime; Set Summertime Date - Enterasys SECURESTACK C3 Configuration Manual

set summertime

set summertime
Use this command to enable or disable the daylight savings time function.
Syntax
set summertime {enable | disable} [zone]
Parameters
enable | disable
zone
Defaults
If a zone name is not specified, none will be applied.
Mode
Switch command, read‐only.
Example
This example shows how to enable daylight savings time function:
C3(su)->set summertime enable

set summertime date

Use this command to configure specific dates to start and stop daylight savings time. These
settings will be non‐recurring and will have to be reset annually.
Syntax
set summertime date start_month start_date start_year start_hr_min end_month
end_date end_year end_hr_min [offset_minutes]
Parameters
start_month
start_date
start_year
start_hr_min
end_month
end_date
end_year
end_hr_min
offset_minutes
Defaults
If an offset is not specified, none will be applied.
3-22 Basic Configuration
Enables or disables the daylight savings time function.
(Optional) Applies a name to the daylight savings time settings.
Specifies the month of the year to start daylight savings time.
Specifies the day of the month to start daylight savings time.
Specifies the year to start daylight savings time.
Specifies the time of day to start daylight savings time. Format is hh:mm.
Specifies the month of the year to end daylight savings time.
Specifies the day of the month to end daylight savings time.
Specifies the year to end daylight savings time.
Specifies the time of day to end daylight savings time. Format is hh:mm.
(Optional) Specifies the amount of time in minutes to offset daylight
savings time from the non‐daylight savings time system setting. Valid
values are 1 ‐ 1440.