Clear Policy Maptable - Enterasys SECURESTACK C3 Configuration Manual

clear policy maptable

Defaults
No mapping table entries are configured.
The default policy maptable response setting is policy mode.
Mode
Switch command, read‐write.
Usage
This command can be used to create entries in the VLAN‐to‐policy mapping table and also to set
the switch's maptable response. Refer to "Operational Description" on page 26‐53 for more
information about the switch's operations for all maptable response parameters.
When you are using VLAN authorization for dynamic VLAN assignment, you should set the
policy maptable response to tunnel. See "Configuring VLAN Authorization (RFC 3580)" on
page 26‐49.
Examples
This example shows how to set the policy maptable response to both, or hybrid authentication
mode:
C3(rw)->set policy maptable response both
This example shows how to configure a policy mapping entry that will map VLAN 144 to policy
profile 4.
C3(rw)->set policy maptable 144 4
clear policy maptable
Use this command to clear a VLAN‐to‐policy mapping table entry or to reset the maptable
response to the default value of policy mode.
Syntax
clear policy maptable {vlan-list | response}
Parameters
vlan‐list
response
Defaults
None.
Mode
Switch command, read‐write.
Usage
This command can be used to remove an entry in the VLAN‐to‐policy mapping table or to change
the maptable response back to the default value of policy mode.
26-56 Authentication and Authorization Configuration
Clears the policy profile mapping for the specified VLAN ID or range of
VLANs.
Resets the maptable response to policy.