Clear Dhcp Pool Hardware-Address; Set Dhcp Pool Host - Enterasys SECURESTACK C3 Configuration Manual

clear dhcp pool hardware-address

Defaults
If no type is specified, Ethernet is assumed.
Mode
Switch command, read‐write.
Example
This example specifies 0001.f401.2710 as the Ethernet MAC address for the manual address pool
named "manual1." Alternatively, the MAC address could have be entered as 00:01:f4:01:27:10.
C3(rw)->set dhcp pool manual1 hardware-address 0001.f401.2710
clear dhcp pool hardware-address
Use this command to remove the hardware address of a DHCP client from a manual binding
address pool.
Syntax
clear dhcp pool poolname hardware-address
Parameters
poolname
Defaults
None.
Mode
Switch command, read‐write.
Example
This example deletes the client hardware address from the address pool named "manual1."
C3(rw)->clear dhcp pool manual1 hardware-address

set dhcp pool host

Use this command to configure an IP address and network mask for a manual DHCP binding.
Syntax
set dhcp pool poolname host ip-address [mask | prefix-length]
Parameters
poolname
ip‐address
16-16 DHCP Server Configuration
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
Specifies the name of the address pool. Pool names may be up to 31
characters in length.
Specifies the IP address for manual binding.