Show Logout; Set Logout - Enterasys SECURESTACK C3 Configuration Manual

show logout

Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the terminal length to 50:
C3(su)->set length 50
show logout
Use this command to display the time (in seconds) an idle console or Telnet CLI session will
remain connected before timing out.
Syntax
show logout
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the CLI logout setting:
C3(su)->show logout
Logout currently set to: 10 minutes.

set logout

Use this command to set the time (in minutes) an idle console or Telnet CLI session will remain
connected before timing out.
Syntax
set logout timeout
Parameters
timeout
Defaults
None.
3-30 Basic Configuration
Sets the number of minutes the system will remain idle before timing out.