Show Spantree Mstilist; Set Spantree Msti - Enterasys SECURESTACK C3 Configuration Manual

show spantree mstilist

Example
This example shows how to reset the bridge priority mode to 802.1t:
C3(rw)->clear spantree bridgeprioritymode
show spantree mstilist
Use this command to display a list of Multiple Spanning Tree (MST) instances configured on the
device.
Syntax
show spantree mstilist
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display a list of MST instances. In this case, SID 2 has been configured:
C3(su)->show spantree mstilist
Configured Multiple Spanning Tree instances:
2

set spantree msti

Use this command to create or delete a Multiple Spanning Tree instance.
Syntax
set spantree msti sid sid {create | delete}
Parameters
sid sid
create | delete
Defaults
None.
Mode
Switch command, read‐write.
9-12 Spanning Tree Configuration
Sets the Multiple Spanning Tree ID. Valid values are 1 ‐ 4094.
SecureStack C3 devices will support up to 4 MST instances.
Creates or deletes an MST instance.